![]() ![]() The data used in read mode is selected by the value in x. The data written is represented in the place "Status Registers" - This command writes to or Whether the modem sends result codes to the DTE or not. "Result Codes to DTE" - This command selects Retraining enabled in on-line command modeĭialing" - This command sets the modem to pulse dial. ![]() Retraining disabled in on-line command mode Probably should never have been created as it uses an O rather than a 0 and can "Retrain Selection" - Confusing command that The N 2-N5Ĭommands will not normally be used by 56k modems. Originate mode and Answer mode v.XX attempts will The full basic Nn command is included for completeness. Where automode is more often controlled by an s-register or the +MSĬommand. Usually more basic (a simple N0 for disabled, N1 for enabled) on 56k modems "Automode selection/detection" - This command is Enable speaker after dialing but disable after a carrier signal is Enable speaker until a carrier signal is detected "Set Speaker Volume" - This command controls the "Report Modem Information" - This command reports The modem is on-hook (hangs up) or off-hook (picks up). "Hook Select" - This command determines whether The modem echos commands sent while in data mode. "Data Mode Echo" - This command controls whether "Echo" - This command controls whether the modemĮchos commands received by the DTE or not. (modem can go off hook for a specifiedĭ Modem will wait for a quiet answer before dialing the rest of the dial Letters enclosed in quotes will be dialed as their corresponding numbers on the dialpad. Resume dialing after dial tone is detected Number with accordance to the modifiers of n. "Dial Control" - This command dials the phone "Transmission Carrier" - This command controls the Selects the v.22 or Bell 212A protocols for data calls. "Select Communication Protocol" - This command Mode" - This command initiates the modem into an auto-answer ThisĬommand will not function properly if preceded by the AT command or followed by Sequence" - This repeats the previous command. However is sometimes used as a command separator in +MS and other commands. "Pause" - The Comma normally initiates a 1-5 second pause, Sequence" - This command initiates an escape sequence to return "Attention!" - This command tells the modem that a command However, most of these commands remain the same, or similar from Many modems do NOT conform to this command Looking for a great deal on High Speed Internet Access? Well look no further! Be certain to check out our sponsor's HIGH SPEED INTERNET DEALS! Compare prices, get discounts, and check availability of Cable Internet, DSL, Satellite & Wireless Broadband!īasic AT Command set. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |